My next video shows off a project that I actually finished late last year already! A DIY heat-recuperation system for our chicken coop to keep our lovely chickens safe and warm <3

www.youtube.com/watch?v=D2nI...

Got back from seeing my first total solar eclipse at Alto Santa Lucía in Spain. The experience is vastly more impressive and prettier in person than any photo or video ever conveys.

Now, it's time to start working on some videos again - hopefully there will be an upload within the next 2 months.

And now for the conclusion! Watch as I install the electric motor I made in my previous video onto a road bike, and then test it out in the field! Did I succeed in making a useful motor? Is it even possible to make a useful motor at home? Only one way to find out! www.youtube.com/watch?v=GDi8...

The, perhaps, long-awaited e-bike motor video is *finally* here! This is the first part in a series of two videos. In this first one, I go over the design- and build process of this from-scratch DIY 500W+ electric motor befit an e-bike.

www.youtube.com/watch?v=6pnC...

As always, the bird center was a lot of fun(but also a lot of work)! Been back home a few days now and I am slowly back working on the latest video.

We had about 4000 birds throughout the time I was there. Pretty good!

Here, have a long-tailed tit, the most common bird we caught during that time.

Sometimes the bird center visitors ask which bird is the hardest to deal with...
Of the common species, eurasian blue tits Cyanistes caeruleus) are certainly one of the fiercest. Their pecks and bites hurt quite a bit and after ringing hundreds of them in a single day, one's fingers will be hurting!

Something I have not talked about in my videos, but could perhaps be quite obvious from my "name" and avatar is that I quite like birds!

In-fact, I somewhat regularly still work with birds to this day. And so, I once again find myself volunteering at Kabli bird center!

Here, have a tawny owl <3

My DIY e-bike motor finally spins up for the first time! <3

Granted, it's not using the proper speed controller yet (which in turn is *totally* not controlled improperly through an Arduino... oops), which means it is running undervolted and in a much narrower speed range than it should.

While I wait for the epoxy of my new diy motor stator to dry, I spent some time making a kind of art piece to put up on the wall at home. It's around 1:100 scale 3d printed "replica" of the Intel 4004 chip silicon die... the world's first commercially available CPU.

Unfortunately, what I was afraid would happen, did happen. 1cm thick 100% infill petg is just not rigid enough to fight against the >100kg of attractive force between the magnets on the rotor and the electrical steel in the stator. Redesign incoming, but means the video will be delayed further.

Today is the day. A project I have been working on on- and off for the past 2 years by now, is finally (hopefully) getting completed today. Hopefully it works as intended and I can get the video about it out in the not too far future!

It's finally happening! Epoxy cast for the diy e-bike motor stator was successful... First assembly and tests in the next few days!

Cheap pressure cooker + old membrane vacuum pump + random leftover tubing and parts = vacuum chamber for epoxy degassing!