#LocateTech
LightNews LightNews
northstarue.bsky.social
Walking the line is where everything you did at the transmitter either pays off or falls apart.

#UtilityLocating #SubsurfaceUtility #SUE #SUI #FieldWork #UtilityDesignation #LocateTech #NorthStarUtilityExperts #InfrastructureSafety #UtilityMapping​​​​​​​​​​​​​​​​
April 8, 2026 at 11:21 AM
northstarue.bsky.social
Use the proper technique while designating buried utilities and make sure you know the limitations of your equipment.

#UtilityLocating #SubsurfaceUtility #SUE #SUI #InductiveClamp #ForcedInduction #PassiveLocating #LocateTech #VivaxMetrotech #InfrastructureSafety #UtilityMapping​​​​​​​​​​​​​​​​
April 3, 2026 at 1:20 PM
northstarue.bsky.social
The three frequencies:
512 Hz
Long distance | Trace wire | Minimal bleed
8 kHz
Everyday workhorse | Direct connect & clamp
33 kHz
Stronger signal | Watch bleed in dense corridors

#UtilityLocating #SubsurfaceUtility #SUE #SUI #FieldWork #GPR #UtilityMapping #NorthStarUtilityExperts #LocateTech
Frequency selection isn’t about the utility. It’s about what’s around it. One of the most common mistakes I see in the field — techs defaulting to the same frequency every single time regardless of the environment. That’s how you end up marking the wrong line. Here’s how I think about it: 512 Hz is your long distance specialist. Minimal signal bleed, ideal for trace wire and telecom runs. Direct connect only — inductive clamp won’t work at this frequency. 8 kHz is your everyday workhorse. Solid range, works with both direct connect and inductive clamp, good balance between signal strength and bleed control. 33 kHz gives you a stronger signal and better clamp performance — but in a congested utility corridor, that stronger signal bleeds onto adjacent lines. Know what’s around you before you dial it in. The environment drives the frequency choice. Always.
March 19, 2026 at 1:50 AM