#mmdvm
Keep your digital radio nets accessible! 📻 A simple 1 to 2 second gap between transmissions allows hotspots to reset & handle RF disconnect commands smoothly. Master MMDVM timing & Pi-Star API controls! 🛰️ #HamRadio #DMR #AmateurRadio
Practical Digital Radio Etiquette: Keeping DMR and System Fusion Nets Accessible
Learn how brief one-to-two-second transmission gaps prevent hotspot lockouts on DMR and Yaesu System Fusion nets. Master digital voice routing, MMDVM modem timing, and Pi-Star BrandMeister API controls to keep your amateur radio node fully responsive over the air.
bdking71.wordpress.com
September 16, 2026 at 11:32 AM
MMDVM Duplex Hotspot Board

Price: Not specified MMDVM Duplex Hotspot Board Multi Mode Digital Voice Modem Support C4FM /DMR /DSTAR/ P25. 1: Raspberry Pi 3 Model B+ Board (3B+) Raspberry PI 3B+. 1: MMDVM Duplex Hotspot Module Dual Hat ( with OLED) 1: 64GB SD card Included. 1: Micro USB cable . View…
MMDVM Duplex Hotspot Board
Price: Not specified MMDVM Duplex Hotspot Board Multi Mode Digital Voice Modem Support C4FM /DMR /DSTAR/ P25. 1: Raspberry Pi 3 Model B+ Board (3B+) Raspberry PI 3B+. 1: MMDVM Duplex Hotspot Module Dual Hat ( with OLED) 1: 64GB SD card Included. 1: Micro USB cable . View listing Go to Source
www.nerfd.net
August 21, 2026 at 6:00 AM
Well you have a good start on D-Star with the D75A
Now I'd suggest a hotspot.
Personally I like Pi-Star based MMDVM hotspots. Cheap, and easily configured, run on a Raspberry PI Zero 2-W now days (A 35 buck computer and the "hat" (MMDVM module) is about the same under 100 to home brew.
August 14, 2026 at 5:08 PM
MOTOROLA UHF REPEATER

Price: Not specified Have a nice Motorola UHF repeater originally set up with 2 Motorola Radius GM300 UHF mobile radios. It was put into service but was upgraded to TAIT radios, which made this assembly redundatant to our needs. Comes with Cabinet with Fan, Power Cables and…
MOTOROLA UHF REPEATER
Price: Not specified Have a nice Motorola UHF repeater originally set up with 2 Motorola Radius GM300 UHF mobile radios. It was put into service but was upgraded to TAIT radios, which made this assembly redundatant to our needs. Comes with Cabinet with Fan, Power Cables and control cables and MMDVM Board, Tx Motorola Mic, NO Duplexer, NO View listing Go to Source
www.nerfd.net
July 30, 2026 at 9:00 PM
I bought a Duplex MMDVM for DMR radio stuff and it has been next to impossible to set up.

Just another anecdote around the world of DMR Ham Radio being needlessly difficult and complex.

I think I might just return this one, even with a new reflash on a different sdcard wi-fi refuses to show up.
July 26, 2026 at 3:49 AM
An MMDVM hat should work fine on both. And consider buying used. I use a 3b I picked up used as a dedicated DMR hotspot.
July 6, 2026 at 7:02 PM
E1758: Hamvention 2026 Exclusive Look at MMDVM & Zumspot Progress

Join us for an exciting update from Hamvention 2026, where Jim from Zoom Spot details the progress of the MMDVM project. Thanks to crucial funding from ARDC, they've made significant strides in amateur radio technology. This…
E1758: Hamvention 2026 Exclusive Look at MMDVM & Zumspot Progress
Join us for an exciting update from Hamvention 2026, where Jim from Zoom Spot details the progress of the MMDVM project. Thanks to crucial funding from ARDC, they've made significant strides in amateur radio technology. This presentation highlights new equipment and software configurations, including an impressive cross-mode setup that supports DMR, DSTAR, and YSF. #zumspot #mmdvm #hamvention Become a supporter of this podcast: Go to Source
www.nerfd.net
June 24, 2026 at 12:02 AM
Reapeater Builder STM32 DVM v4 board

Price: Not specified Never used; was going to make a high-powered DMR hotspot, but like so many things, never got around to it. From their website; STM32_DVM_USB: Special Limited Time Price – $110  USD This is a modem board version for folks that aren’t running…
Reapeater Builder STM32 DVM v4 board
Price: Not specified Never used; was going to make a high-powered DMR hotspot, but like so many things, never got around to it. From their website; STM32_DVM_USB: Special Limited Time Price – $110  USD This is a modem board version for folks that aren’t running MMDVMHost on a Raspberry Pi. This version requires an external platform running MMDVM View listing Go to Source
www.nerfd.net
June 8, 2026 at 12:00 AM
UHF MMDVM Hotspot board on Rpi Zero w with SD card

Price: Not specified UHF MMDVM Hotspot board on Rpi Zero w with SD card works well with an outside antenna. View listing Go to Source
UHF MMDVM Hotspot board on Rpi Zero w with SD card
Price: Not specified UHF MMDVM Hotspot board on Rpi Zero w with SD card works well with an outside antenna. View listing Go to Source
www.nerfd.net
June 5, 2026 at 6:00 PM
Yaesu FT-70DR FM/C4FM Dual band handheld

Price: Not specified Yaesu FT-70DR FM/C4FM Dual band handheld.  Excellent condition. Never dropped or dunked.  Non-smoking household. Includes optional speaker-mike.  Will throw in an MMDVM hotspot as well if you like. View listing Go to Source
Yaesu FT-70DR FM/C4FM Dual band handheld
Price: Not specified Yaesu FT-70DR FM/C4FM Dual band handheld.  Excellent condition. Never dropped or dunked.  Non-smoking household. Includes optional speaker-mike.  Will throw in an MMDVM hotspot as well if you like. View listing Go to Source
www.nerfd.net
June 1, 2026 at 12:00 AM
Happy days. Spent £35 on a new Pi 3B+. Should have tried disconnecting the MMDVM HAT first, because that's where the fault is. Oooops.
Now I have to apply 3.3V and figure out what's shorted out. Probably a ceramic capacitor. Hopefully not an IC.
May 12, 2026 at 1:47 PM
These MMDVMs are rad. :3
March 13, 2026 at 2:53 AM
I have 4 Pi-stars here
Pi a, Pi b Pi c and Pi-spare (Still in it's box just in case)
Average cost about 50 bucks but cost more today
They run free Pi-Star software (Andy's version) on a Raspberry Pi-Zero w (no longer made but the zero 2 w is $35.00) With an MMDVM module (about 20-30 dollars)
March 2, 2026 at 1:38 PM
Another win for MacGyver!

I successfully reused a recovered Vaisala RS41 radiosonde with Mysondy Go running Nevvman18 rs41-nfw firmware, and I set up an APRS iGate using a Pi-Star installation (rtl_fm & Direwolf) and an SDR v3 clone "the green" (Not MMDVM hw)

My raw on Notes in ea5jtt.blogspot.com
March 1, 2026 at 8:44 AM
In other news, F4FXL has pushed a PR to MMDVMHost so that D-Star repeaters can finally support DV Fast data transparency
github.com/g4klx/MMDVMH...
Enable and fix DStar Fast Data by F4FXL · Pull Request #852 · g4klx/MMDVMHost
Hi Jonathan, As posted here this is what @dscp46 and me have been working on in the last days. It has been tested on 3 repeaters with various MMDVM Firmware version (one even running a 5 years old ...
github.com
January 28, 2026 at 6:26 AM
I will build a transmitter for the #DAPNET. Material is ordered. An MMDVM with a 70cm band amplifier with 10 watts. Who has experience with it? #Pocsag
December 27, 2025 at 9:21 PM
The Short Stack consists of tidbits pulled from many sources. This content tends to be more stream-of-consciousness and range more widely than longer, more focused sections that follow. www.randomwire.us/p/random-wir... #hamradio
Random Wire 157: Part 1 on the m1ke WLAN IP transceiver, plus another MMDVM hotspot.
November 14, 2025: I begin a series on the m1ke WLAN IP transceiver in this issue, with future installments planned as I get more comfortable using the device.
www.randomwire.us
November 17, 2025 at 11:36 PM
* LinHT: An Open-source SDR Handheld Radio
* MESHCON 2025 Wakeup Call to AR
* Test Bench In A (Handheld) Box
* direwolf Rel 1.8
* IP400
* 44Net VPN Update
* New AllScan Units
* The Comm 11/12 2025 Issue
* FutureGEO
* SDR-Hub
* MMDVM 2025-10 Update
* Hackaday Superconference Comm Badge

#hamradio
Zero Retries 0226
2025-10-31 — LinHT Article (by the developers), MESHCON 2025 is a Wakeup Call, Test Bench in a Hand, N8GNJ Standby Battery System, direwolf 1.8, New AllScan USB Radio Interfaces, MMDVM Update
www.zeroretries.org
November 3, 2025 at 4:43 AM
I posted these to the VK D-Star Facebook group. I’ll post the responses I get. Hi everyone, I recently acquired an MMDVM hotspot and have joined the D-Star universe. 

I am after some feedback on the following, please. andrewwoodward.net/2025/09/14/n... #dstar #amateurradio #hamradio #vk #icom
New to D-Star

 in VK/AU – questions
I posted these to the VK D-Star Facebook group. I’ll post the responses I get. Hi everyone, I live in country NSW (Bellingen) and have a 52A+. I recently got an MMDVM hotspot and am now in th…
andrewwoodward.net
September 14, 2025 at 8:20 AM